Using a cutter knife or the special tool, scrape the oil sealant smoothly to a thickness of about 2 mm on the bonding surface around the entire tailgate flange.
CAUTION
Be careful not to remove more adhesive than necessary, and also not to damage the paintwork on the body surface with the knife. If the paintwork is damaged, repair the damaged area with touch-up paint.
Clean the body flange surface of tailgate aperture with a sponge dampened in solvent.
Apply the primer to body flange surface of tailgate glass.
To use primer, shake the vessel in ten minutes or more.
Clean the primer-applied parts of tailgate glass.
Clean completely contaminants such as oil and dust in the primer-applied parts of tailgate glass.
After cleaning the tailgate glass, pass a minute or more and apply the primer to tailgate glass.
Adhere dam to tailgate glass.
Adhere the dam at regular intervals from the lower edge.
Moulding installation in tailgate glass.
When working the moulding installation in tailgate glass, install the "A" part of moulding on the standard of "B" part of tailgate glass.
When inserting the moulding, be careful not to change the directions.
Primer application to tailgate glass.
To. use the primer, shake the primer vessel in ten minutes or more.
Apply sealant to tailgate glass.
Using the special too1 (09861-31400), install the tailgate glass.
Installation of the each trim parts is the reverse of the removal procedure.
CAUTION
Before operating tailgate wiper arm, solidify completely sealant.