SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2000
GROUP
Heating, Ventilation & Air Conditioning Air Conditioning System
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

REMOVAL AND INSTALLATION CONDENSER 
NOTE
Plug all of the open fittings immediately after removal to keep moisture out of the system.
  1. Discharge refrigerant from the air conditioning system. (For detailed removal procedures for No.2 through No.8, refer to the "Removal of the liquid tube (B)" on page HA-76)

  1. Remove the air intake duct assembly.

  1. Remove the radiator upper mounting clamps.

  1. Remove the radiator upper grille.

  1. Remove the liquid tube (A).

  1. Disconnect the liquid tube (B) and remain it with removed state.

  1. Remove the receiver drier.

  1. Remove the receiver drier mounting bracket.

  1. Remove the condenser mounting bolts.

  1. Remove the condenser assembly.

    NOTE
    Be careful not to damage the condenser fins.
  1. Installation is the reverse order of removal.

    NOTE
    1. While installing each of removed fitting, replace O-ring (if exists) and apply specified lubricant.
    2. Be careful not to bend or twist refrigerant lines in order to install them easily.
    3. After installation, evacuate, charge and test the air conditioning system.
CONDENSER FAN
  1. Disconnect the connector of the condenser fan.

  1. Remove mounting screws.

  1. Remove the condenser fan assembly.

  1. Installation is the reverse order of removal.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

COMPONENTS