SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2001
GROUP
Brake Systems Conventional Brake System
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

BRAKE PEDAL COMPONENTS 
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DISASSEMBLY 
  1. Remove the stop lamp switch.

  1. Remove the flange nuts (4EA) & bolt (1EA) of the brake mounting bracket.

  1. Remove the clevis pin.

  1. Remove the brake pedal assembly.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSPECTION 
  1. Check the bushing for wear.

  1. Check the brake pedal for distortion.

  1. Check the brake pedal return spring for damage.

  1. Check the stop lamp switch.

    1. With an ohmmeter connected to the stop lamp switch terminals, check for continuity.
    1. If there is no continuity when the plunger is depressed and there is continuity when the plunger is released, the stop lamp switch is normal
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSTALLATION 
  1. Apply chassis grease to the sliding surface of the brake pedal and operating rod clevis pin.

    CAUTION
    Be sure to install the split pin on the operating rod clevis pin.
  1. Install the brake pedal assembly and tighten the flange nuts (booster mounting nuts) and bolt.

    TORQUE SPECIFICATION
    Tighten the flange nuts 8-12 Nm ( 80-120 kg·cm, ? lb·ft )
  1. Adjust the brake pedal height and free play.

  1. Install the stop lamp switch.