SERVICE MANUAL
Applies to:
Hyundai Coupe/Tiburon
1998-2001
GROUP
Brake Systems
Conventional Brake System
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
BRAKE PEDAL COMPONENTS
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
DISASSEMBLY
Remove the stop lamp switch.
Remove the flange nuts (4EA) & bolt (1EA) of the brake mounting bracket.
Remove the clevis pin.
Remove the brake pedal assembly.
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
INSPECTION
Check the bushing for wear.
Check the brake pedal for distortion.
Check the brake pedal return spring for damage.
Check the stop lamp switch.
With an ohmmeter connected to the stop lamp switch terminals, check for continuity.
If there is no continuity when the plunger is depressed and there is continuity when the plunger is released, the stop lamp switch is normal
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
INSTALLATION
Apply chassis grease to the sliding surface of the brake pedal and operating rod clevis pin.
CAUTION
Be sure to install the split pin on the operating rod clevis pin.
Install the brake pedal assembly and tighten the flange nuts (booster mounting nuts) and bolt.
TORQUE SPECIFICATION
Tighten the flange nuts
8-12
Nm
(
80-120
kg·cm
,
?
lb·ft
)
Adjust the brake pedal height and free play.
Install the stop lamp switch.