SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2000
GROUP
Transaxle/Transmission Automatic Transaxle System
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DISASSEMBLY (continued) 
  1. Using an impact driver, loosen and remove the bearing retainer.

  1. Remove the bearing retainer.

  1. Remove the snap ring from the bearing.

  1. Loosen the rear cover mounting bolts and remove the rear cover.

  1. Stand the transfer shaft lock nut caulking by punch.

  1. Install the special tool to the transaxle case.

  1. Remove the locking nut.

  1. Using the special tool, remove the transfer driven gear

  1. Using the special tool, remove the taper roller bearing outer race. Remove the taper roller bearing outer race.

  1. Remove the snap ring.

  1. Remove the transaxle shaft and taper roller bearing.

  1. Move the manual control lever from the "P" position to "N" position.

  1. Remove the snap ring from the output flange assembly.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DISASSEMBLY (continued) 
  1. Remove the stopper plate.

  1. Using the special tool or presser, remove the output flange and drive gear.

  1. Remove the speedometer sleeve.

  1. Remove the differential cover and the gasket.

  1. Before removal of the differential gear, measure the end play of the deferential gear with a dial gauge.

  1. Remove the 5 differentiai bearing retainer mounting bolts.

  1. Using the special tool, remove the differential bearing retainer.

  1. Loosen the mounting bolts and remove the bearing cap.

  1. Remove the differential assembly.

  1. Remove two bolts of the sprag rod support and the bolt of the detent spring assembly.

  1. Remove the set screw and the manual control shaft assembly. Remove the sprag rod and the detent spring assembly.

  1. Remove the kickdown servo snap ring.

  1. Remove the kickdown piston assembly.