SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2001
GROUP
Engine Mechanical System Cooling System
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSPECTION 
  1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.

  1. Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.

  1. Check for coolant leakage. If coolant leaks from hole "A", the seal is defective. Replace the coolant pump assembly.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DISASSEMBLY 
  1. Drain the coolant and disconnect the coolant outlet pipe connection hose from the coolant pump.

  1. Remove the drive belt and engine coolant pump pulley.

  1. Remove the timing belt covers and the timing belt idler.

  1. Remove the coolant pump mounting bolts, then remove the generator brace.

  1. Remove the coolant pump assembly from the cylinder block.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

COMPONENTS 
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

REASSEMBLY 
  1. Clean the gasket surfaces of the coolant pump body and the cylinder block.

  1. Install a new coolant pump gasket to the coolant pump and tighten the bolts to specified torque.

    TORQUE SPECIFICATION
    Coolant pump to cylinder block 20-27 Nm ( 200-270 kg·cm, 14-20 lb·ft )
  1. Install the timing tensioner and timing belt. Adjust the timing belt tension.

  1. Install the timing belt covers.

  1. Install the coolant pump pulley and drive belt, and then adjust the belt tension.

  1. Refill the system with clean coolant.

  1. Run the engine and check for leaks.