SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2001
GROUP
Body (Interior & Exterior) Hood, Doors & Trunk Lid
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

COMPONENTS 
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DOOR POSITION ADJUSTMENT 

Check for flush fit with the body, then check for equal gap between the front and rear, top and bottom door edges and the body.

The door and body edges should also be parallel. Adjust at the hinge with the Special Tool (09793-21000).

CAUTION
Attach protective tape to the fender edges near the place where the hinge is installed.
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

DOOR STRIKER ADJUSTMENT 

Make sure the door is not loose and latches securely without slamming. If it needs adjustment;

  1. Draw a line around the striker plate for reference.

  1. Loosen the striker screws and move the striker inward or outward to make the latch fit tighter or looser. Move the striker upward or downward to align it with the latch opening. Then lightly tighten the screws and recheck.

    NOTE
    Hold the outside handle out and push the door against the body to be sure the striker allows a flush fit.
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSIDE DOOR HANDLE ADJUSTMENT 

Adjust the inside handle play by adjusting the mounting position in the IN-to-OUT direction.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

REMOVAL AND INSTALLATION 
  1. Remove the door window regulator handle and then remove clip using a piece of cloth (Manual type only).

  1. Remove the inside handle housing.

  1. Remove the power window switch.

    Disconnect the power window switch connector.

  1. Remove the mounting screws from the grip handle, and remove the door trim panel.

    Disconnect the door lamp connector.

  1. Remove the door grip handle mounting bracket, and inside handle mounting bracket and then door trim seal.

  1. Remove the door glass stopper catch.

  1. Remove the glass stopper bolts, and carrier plate bolts from the door glass, and then pull out the door glass through the window slot.

  1. Remove the power window door regulator mounting bolts and then disconnect the power window regulator connector.

  1. Remove the mounting bolt and nut from the door glass channel.

  1. Remove the door outside belt moulding.

  1. Remove the door outside mirror and door delta chassis.

  1. Remove the door outside handle from the door latch rod.

  1. Remove the door latch and door lock actuator mounting screw and bolt.

    Disconnect the door actuator connector.

  1. Remove the door checker.

  1. Installation is the reverse of the removal procedure.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

COMPONENTS