SERVICE MANUAL
  Applies to: Hyundai Coupe/Tiburon 1998-2001
GROUP
Suspension System Rear Suspension System
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

COMPONENTS 
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

REMOVAL 
  1. Remove the rear speed sensor (Vehicles with ABS)

    CAUTION
    When removing the speed sensor from the adapter, be careful that the end pole piece does not strike the teeth of the rotor or other parts.
  1. Remove the caliper assembly and suspend it.

  1. Remove the brake disc.

  1. Remove the hub cap, wheel bearing nut and tongued washer.

  1. Remove the rear hub assembly.

    CAUTION
    The rear hub unit bearing should not be dismantled.
    CAUTION
    (Vehicles with ABS) Care must be taken not to scratch or otherwise damage the teeth of the rotor, The rotor must never be dropped. If the teeth of the rotor are chipped, resulting in a deformation of the rotor, it will not be able to accurately detect the wheel rotation speed, and the system will not function normally.
Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSPECTION 
  1. Check the oil seal for cracks or damage.

  1. Check the rear hub unit bearing for wear or damage.

  1. Check the rear rotor for chipped teeth.

Return to Main Menu(s):      Mechanical Manual      Electrical Manual

INSTALLATION 
  1. After tightening the wheel bearing nut, crimp the nut to meet the concave portion of the spindle.

  1. Installation of rear speed sensor (Vehicles with ABS):

    Insert a feeler gauge into the space between the speed sensor's pole piece and the rotor's toothed surface, and then tighten the speed sensors at the position where the clearance at all places is within the standard value.

    MEASUREMENT SPECIFICATION
    Clearance 0.2-1.3 mm ( 0.008-0.051 in )
  1. Install the hub cap.