REMOVAL
NOTE
Before removing the front axle assembly, disconnect the ABS wheel sensor from the assembly and move it away from the front axle assembly area. Failure to do so may result in the sensor wires being damaged and the sensor becoming inoperative.
Remove the drive shaft nut. Jack up the vehicle and support it with jack stands. Remove the wheel and tire.
Remove the front brake assembly from the knuckle and suspend with a wire.
NOTE
Brake hose does not need to be disconnected from brake caliper. Be careful not to depress brake pedal, or piston will pop out.
Disconnect the lower arm ball joint from the knuckle using the special tool.
-
Using the special tool, remove the drive shaft nut.
-
Disconnect the tie rod and ball joint from the knuckle using the special tool.
NOTE
-
Be sure to tie a cord to the special tool and to a nearby part.
-
Loosen the nut but do not remove it.
-
Disconnect the drive shaft from the hub using the special tool.
-
Remove the hub and knuckle as an assembly from the strut.