SERVICE MANUAL
Applies to:
Hyundai Coupe/Tiburon
1998-2001
GROUP
Clutch System
Clutch Components
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
REMOVAL
Drain the clutch fluid through the bleed plug.
Remove the clevis pin, washer and cotter pin.
Disconnect the clutch line (master cylinder side).
Remove the master cylinder mounting bolt.
Remove the clutch line clips.
Hold the nut on the clutch hose and loosen the flare nut on the clutch line.
Remove the clip from the clutch hose and remove clutch hose from bracket.
Remove the clutch line.
Disconnect the clutch tube (Clutch hose side).
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
REASSEMBLY
Connect the clutch tube (Clutch hose side).
Temporarily tighten the flare nut by hand, and then tighten it to the specified torque, being careful that the clutch hose does not become twisted.
TORQUE SPECIFICATION
Clutch tube flare nut
13-17
Nm
(
130-170
kg·cm
,
9-13
lb·ft
)
Install the clutch line and clips.
Install the master cylinder.
Apply the specified grease to the clevis pin and washer.
Specified grease: Wheel bearing grease SAE J310a, NLGI No.2
Install the push rod to the clutch pedal.
Refill the clutch master cylinder with fluid.
Bleed the system
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
INSPECTION
Check the clutch hose or tube for cracks or clogging.
Return to Main Menu(s):
Mechanical Manual
Electrical Manual
COMPONENTS